/ Register

Requesting Help With Weird Wiring for P/J Bass

Discussion in 'Pickups & Electronics [BG]' started by heroellis, Nov 10, 2018.

Tags:
  1. Nov 10, 2018 #1
    heroellis

    heroellis Guest

    Nov 10, 2018
    Hi Everyone!

    I'm trying to wire a P/J bass with the following configuration, does anyone know if this is possible/easy?

    P neck pickup and j bridge pickup wired to one volume and push pull tone, when tone not pulled, both pickups wired in parallel, when pulled, just P pickup (With tone and volume engaged).

    It seems like it would be relatively simple, I just don't know where I would put the hot for the bridge pickup or the neck pickup. Thoughts?

    Thanks again,

    heroellis
     
  2. Nov 10, 2018 #2
    Killed_by_Death

    Killed_by_Death Snaggletooth Inactive

    Jan 2, 2015
    14 Megameters from Groong Tehp
    The + wire for the P pickup will go to the volume pot like normal.
    The + wire for the bridge pickup will go to the push/pull to connect or disconnect from the same spot that the P pickup is connected to the volume pot.
     
  3. Nov 13, 2018 #3
    bigtone23

    bigtone23

    Dec 10, 2014
    Denver, CO
    This is not weird wiring at all, but to the point. It's the only two settings I use on a P/J.