1. Please take 30 seconds to register your free account to post, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

seeking passive rewiring/shielding advice

Discussion in 'Pickups & Electronics [BG]' started by billoetjen, Oct 13, 2005.


  1. Hi -
    I'm in the midst of replacing the p/u's on my passive p/j Ibanez bass. Putting in Dimarzio passive replacement set. Also lining the cavity with copper and replacing the pots with Dimarzio 500 K pots.
    So far, the BAD hum/buzz from the J pickup is gone (thanks I think to the humbucking design of the new pup.
    Now, unfortunately, I'm getting more buzzing from other sources. It disappears when I touch the bridge. Maybe I didn't ground the bridge wire well enough? Should all grounds be tied together at the output jack ground?
    I'd appreciate any suggestions, sites, shared experiences, etc.

    Thanks,
    Bill :help:
     
  2. Lyle Caldwell

    Lyle Caldwell

    Sep 7, 2004
    Memphis
    Check the FAQ in this forum for shielding instructions.