solutions for boards with integrated IEC sockets

so, after being on the hunt for the board with the cleanest potential, i bought a schmidt array SA450...it has an integrated IEC connector built into the board, however, the decibel eleven supply i got doesn't align with the plug, e.g, the supply would ideally just fit flush against the back of the board with the IEC connector being neatly mated...are there any solutions that exist that could fix this? like right angle IEC extension cables that are only a couple of inches long? i attached a pic to illustrate what i'm talking about...thanks!

 

Cool, thanks guys! I am looking for one with angles on it, or a jumper plug, but even the custom cord builders list 1 foot as the shortest length they will make...I will have to contact someone directly...I only need it to be three or four inches