1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Speakers for a 4x10" on a budget.

Discussion in 'Amps and Cabs [BG]' started by Hellbastard, Sep 25, 2008.


  1. Hey guys, I've been thinking about buying some speakers for a 4x10" cab I had made a couple of years ago.
    The options I'm looking to are:
    http://www.mcmelectronics.com/product/55-1740 which from the search I made are an onexpensive alternative to Eminence Beta 10s
    http://www.mcmelectronics.com/product/55-1300 since I've always wanted to try aluminium cone speakers.
    Now the questions are which ones would work better on a cab which dimensions are:
    H: 21"
    W: 21"
    D: 13 1/2"
    :help:
     
  2. xaosbass

    xaosbass

    Feb 15, 2008
    Using WinISD and the box volume of your cab, (2.64Ft3) assuming it is made w/ 3/4" material, you could put 4 of the 55-1740 MCM 10's in your box unported or ported and you would end up w/ the same F3, so porting would not get you much. Both end up w/ an F3 of roughly 90-94 Hz. they have descent excursion so that might help. seems that your box is a bit small for 4 of these drivers, keeping any more extension to the low end from happening.
     
  3. The cab is made of 3/4" plywood. The cab is sealed and it's got a port in the middle of 4" of diameter and 3 3/4" of depth.
    I have this ca made after the This
    [​IMG]
    Little I knew that the circle in the middle was actually a horn.
    So, would this port affect the cab?
    Or should I also place a horn in the middle?
    I'm looking to get 8ohm out of this cab.

    Thank you in advance
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.