/ Register

Split coil switch inner/both/outer

Discussion in 'Pickups & Electronics [BG]' started by Travis207James, Jul 9, 2013.

  1. Jul 9, 2013 #1
    Travis207James

    Travis207James

    May 10, 2013
    Maine
    I want to do a coil split with a 3 way switch where one side does middle coils, the middle is humbucker, and the other side is the bridge coils.

    I'm not sure how to wire this though, every diagram I've seen has been with push/pulls and only for one coil so I'm a little confused.

    I'm also not sure on what switch I would need. A DPDT on/off/on? Or, a on/on/on?

    I drew a terrible diagram of how I think it would be wired, but, I don't know where the ground wires from the humbucker would go.
     

    Attached Files:

  2. Jul 9, 2013 #2
    Jazz Ad

    Jazz Ad Mi la ré sol

    Mar 16, 2002
    Langueux, Brittany, France
    It's very simple. Think of it as a pickup selector.
    Single switch on-on-on, wire the hot from each coil on a side, output on middle peg, done.
     
  3. Jul 9, 2013 #3
    ex-tension

    ex-tension

    Jun 11, 2009
  4. Jul 9, 2013 #4
    line6man

    line6man

    Jun 20, 2008
    Close to Los Angeles, CA
    4044630163_661f69db30_o.png
     
  5. Jul 9, 2013 #5
    Travis207James

    Travis207James

    May 10, 2013
    Maine
    Sweet thanks everyone.