$45 Shipped - CONUS48 - NO TRADES 18x9x3.25(back) Stickman is a pedal board builder from Georgia on Reverb. Store->Stickman Pedal Boards Here is the description from the original listing: "Triboard 18" This handmade pedal board features lacquer coated solid oak boards that are very strong and still lightweight. 3D printed end caps hold it all together and are very strong. Three boards with 16x9 inches of space will accommodate 8 Boss sized pedals, or 14 mini sized with cables. Tons of room below to mount most power supplies. Over 2.5 inches of clearance in the back and 1.5 inches in the front. This board has a 8 degree tilt for better visibility of your settings. I hand build these pedals using 3D printed end caps and lacquer coated solid oak runners. Each board will include enough velcro to attach pedals the length of the top and to mount a power supply underneath, and some foam rubber feet so it won't slide around. This ad is for the Triboard 18" With black end caps and oak boards. Total width is 18 inches, this includes the end caps that are 2 inches total. So the flat board space is 16.0 inches wide. Measurements are : 18 inches wide, 9 inches deep, 3.25 inches tall in rear. Total weight is 2.25 lbs" Excellent condition with just a few light scuffs. Comes with wide Strenco velcro installed as well as the original 1" velcro and rubber feet that he supplied with the board that I never installed. Only selling because I outgrew it and ordered one of his larger boards.