/ Register

SWR Goliath III Replacement Drivers?

Discussion in 'Amps and Cabs [BG]' started by SCBassquatch, Aug 9, 2017.

Tags:
  1. Aug 9, 2017 #1
    SCBassquatch

    SCBassquatch

    Aug 9, 2017
    I currently have a SWR Goliath III, and two of the cones have ripped. Should I look into having the cones repaired, or should I just replace the drivers all together? If I do replace the two, what should I replace them with? I guess the original PAWs that are in there are no longer available. I found this set on Ebay ( 4 pack 10" 8 Ohm Eminence SWR Goliath Woofer Midbass Bass Guitar Speaker USA | eBay ) but I only need two. Suggestions? Thanks!!
     
  2. Aug 18, 2017 #2
    sheltjo6

    sheltjo6 Supporting Member

    Jun 10, 2012
    California
    Depends on the cost.

    I had my Goliath II Jr speakers reconed a few years ago simply because they were the PAS speakers, which are no longer manufactured and hard to find used.

    If I remember correctly, The cost was approximately $75 per speaker.

    I've had no issues using reconed speakers.
    It's worth investigating.
     
    SCBassquatch likes this.
  3. Aug 19, 2017 #3
    murphy

    murphy Supporting Member

    May 5, 2004
    Canada
    Just remember to only use the correct recone kits....might not be cheaper to get done, but will be correct
     
    SCBassquatch likes this.
  4. Aug 20, 2017 #4
    Nephilymbass

    Nephilymbass

    Feb 7, 2011
    Fayetteville/ Ft Bragg, NC
    Eminence bp102
     
    SCBassquatch likes this.