1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

SWR Workingman 4004: Both channels into Acoustic B410?

Discussion in 'Amps and Cabs [BG]' started by SPAZ5446, May 15, 2011.


  1. SPAZ5446

    SPAZ5446

    Aug 25, 2010
    Massachusetts
    So I recently purchased a SWR 4004 head and a Acoustic B410 cab from Daddy's and was wondering, since the B410 has parallel jacks, can both the left and right signal of the SWR head be plugged into both jacks without causing problems? The manual for the head says no where that it can be bridged but would this be classified as bridging?
     
  2. It seems to be a mono head and as such cannot be bridged. For that you need a stereo amp. The outputs from the amp are identical so just use one speaker cable to connect the cabinet.
     
  3. RickenBoogie

    RickenBoogie

    Jul 22, 2007
    Dallas, TX
    +1 don't attempt to connect 2 spkr cables from the amp to the cab, it could potentially fry your amp.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.