1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Tube modifications and combinations

Discussion in 'Pickups & Electronics [BG]' started by The_Lucek, Jun 3, 2014.


  1. The_Lucek

    The_Lucek

    May 21, 2011
    Hello to all,
    In this thread we'll be discussing some technical and electronic stuff. For starters this will be my summer vacation project. A combination of the svt cl and a 4 el34 power section. Hopefully for a 100w trough a single 15 inch eminence speaker. Now, the pre is no big deal. Just finished a Marshall plexi pre for a friend and it turned out grate.
    For the output stage I figured I'd just use the jcm800 schematic. Now, what modifications should be done to the pi and driver tubes of the svt to be compatible to the el34s? The output tranny has yet to be wound as is the case with the power transformer.
    And a bias knob for every tube. Will that require an extra tube?
    Hope it is posible to make one.

    PS The cost won't be to big? For the pre it was mostly tubes and cosmetics.
     
  2. Dave W

    Dave W

    Mar 1, 2007
    White Plains
    You'll probably want this moved into the Amps section
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.