1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Undersized headstock holes or Oversized tuner bushings ?

Discussion in 'Hardware, Setup & Repair [BG]' started by Godfather, Apr 18, 2010.


  1. Godfather

    Godfather

    Feb 4, 2001
    Hi folks

    I recently picked up a Warmoth Tele bass neck to install on a Fender bullet bass body......I got it without tuners, so I picked up a set from a late model MIM P-bass, the bushings of which are listed as 11/16 of an inch......When I went to install them, the bushing would not go in.....I measured out the holes to be 17mm in diameter ( .669 inches) .....11/16 of an inch calculates to .6875 inches.....
    Am I missing something here?....any help would be appreciated !

    cheers
    Godfather
     
  2. I don't understand what the question is.

    The tuners are too large for the holes. I'd either enlarge the holes or get smaller tuners.
     
  3. Godfather

    Godfather

    Feb 4, 2001
    Gee, Justdavid- thanks !...that had not occurred to me :rolleyes:
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.