1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

SOLD Weber Mass 3 Attenuator

Discussion in 'For Sale: Other Stuff (Not bass related)' started by Nomad5, Jul 5, 2017.

  1. Nomad5

    Nomad5 Gold Supporting Member

    Jan 23, 2010
    Dallas, Texas
    From the Weber Site:

    This attenuator has three knobs for tonal control. The main volume is controlled by the BASS knob. Then to control the mids and treble, use the MIDDLE knob and TREBLE knob. The middle and treble controls are always dependent on the main volume control. Be aware that the higher the setting on the main knob, the less the effect of the treble compensation. For instance, if you turn the main knob all the way to 10, you'll notice very little change in the tone as you turn the treble compensation from one end to the other. The line out signal EQ is dependent on your amplifier settings, with only a volume and tone control on the unit.

    May be used on 4, 8, and 16 ohm amplifiers. This MASS is unique in that it has an actual tone stack for the speaker signal -- BASS - MIDS - TREBLE. It also has the internal speaker motor for the load, and has a variable line out signal with volume and tone. The unit has two speaker output jacks to support multiple cabinets. The three tone controls can take the signal from whisper quiet to full on with slight humps in the bass, mids, and treble.

    Additionally, the MASS III has an active bypass circuit with a footswitch so you can run attenuated or bypassed. The footswitch has a 12' cable, and the power pack for the switching relays is a 7.5VDC wall wart. With no power applied, the attenuator is still usable. The power is just for the footswitch circuitry.

    Like all Weber attenuators, you can turn all attenuator controls to zero, pull the speaker, and just use the line out, making the MASS III a dummy load.

    Optional wings may be employed for rackmounting the MASS (sold separately). The MASS III occupies two rack spaces and requires adequate ventilation for proper operation.

    This item is hand-built to order, to ensure the best attention to detail is paid to its construction. We build them one at a time, on a table - not hundreds at a time on an assembly line. This allows us to reduce the margin for error and produce an overall higher-quality product. Please allow at least 7-10 business days for your order to be built and then shipped.

    I ordered this in early 2016, and have used it exactly once. Works perfectly and can tame any amp out there! I used it with a JCM800 with great results. Sells for $286. I'm asking $200 OBO Shipped CONUS.


    IMG_5653.JPG IMG_5654.JPG

Share This Page