1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

What glue do I use for a nut on a P-Bass?

Discussion in 'Hardware, Setup & Repair [BG]' started by ctcruiser, Feb 27, 2005.


  1. ctcruiser

    ctcruiser

    Jan 16, 2005
    West Haven, CT
    I need to replace the nut on my '75 P-Bass with a maple neck. What kind of glue do I use?
     
  2. jpo259

    jpo259

    Feb 2, 2005
    Corona, CA
    I just made and installed a new nut for my Fender Aerodyne yesterday. I used 5-minute epoxy. Ain't NOBODY can tell me that that was not wise! The nut I made was a HUGE improvement over the stock piece of #@$!. And, it's made of black water buffalo horn and matches the all-black bass oh so well!!! That was a fun project, too!! Took me 1.5 hours!! Polished up the nut and everything!
     
  3. Bob Rogers

    Bob Rogers Left is Right

    Feb 26, 2005
    Blacksburg, Virginia
    I make sure the slot is nice, clean and square and the nut fits it exactly. Then I just use a thin smear of carpenters glue to make sure it doesn't slide from side to side. That way it's easy to knock out if (when) it needs to be replaced.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.