1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

wiring a piezo bridge

Discussion in 'Luthier's Corner' started by bound, Dec 28, 2003.

  1. bound


    Dec 28, 2003
    Jersey, Baby!
    I've got this piezo bridge for a six string that has individual wires for each saddle. Do i need some sort of buffer or booster to match the output level of the active electronics that i'm putting in the bass? I'm going to be using bartolini triple coil humbuckers and the Bartolini EZQ. I'd like to be able to blend the signals from each to a single output.
    thanks for any help!:)
  2. FBB Custom

    FBB Custom TalkBass Pro Commercial User

    Jan 26, 2002
    Owner: FBB Bass Works
    You need their MPB magnetic/piezo blend module. You should be able to get it wherever you got the MM pickup.

    You wouldn't happen to have the wiring schematic for the EZQ would you? I have one of the EZQs but I don't have a wiring diagram.
  3. brandinstroy

    brandinstroy Supporting Member

    Feb 21, 2001
    Colorado Springs, CO
    I Support the following: Fodera, Noble Amps, JHAudio, Trickfish Amplification
    I have a wiring diagram for the EZQ preamp.
    I actually have 2 different ones.

    pm or mail me and I can get it to you
  4. bound


    Dec 28, 2003
    Jersey, Baby!
    wow, hey, if you could email me the wiring diagrams for the ezq, also, that would be way cool. i've had two of them sitting around for years, but i've lost all the paperwork that came with them.
    thanks for the info on the bridge, too, I kind of figured that that was what i needed, but bartolini's website isn't finished, so there wasn't too much information on it..
    thanks, tim

Share This Page