1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

wiring... HELP!!

Discussion in 'Pickups & Electronics [BG]' started by lo-end, Jul 30, 2001.

  1. lo-end


    Jun 15, 2001
    I just bought a seymour duncan quarter pound for p bass pickup. I put it in my p bass and started to wire it but some of the wires got messed up and now I have a dilemma. I was wondering if the 3 little tabs on a pot that stick out on one side - does it matter which oner of these tabs you solder the wire onto? Is there a specific one that it needs to be soldered to or does it not matter? Please help! my bass doesnt work at all. By the way, I have a P/J config that I'm changing to a P config with one vol and one tone. I am getting rid of the other vol.
  2. jwymore


    Jul 26, 2001
    Portland, OR
  3. lo-end


    Jun 15, 2001
    well that sorta helps but not really... I just wanna know about the pots.
  4. Pick the one with bits of solder residue on it.

Share This Page