1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

wiring piezo in 410 cab

Discussion in 'Amps and Cabs [BG]' started by Kevinlee, Oct 25, 2005.


  1. Kevinlee

    Kevinlee

    May 15, 2001
    Phx, AZ..USA
    I'm putting a LeSon piezo tweeter into a 410 cab. I've been reading through the post and so far I've gathered to wire it in parallel and it does not need a crossover but a cap and or resistor can be used.

    Ok, so does it mater what speaker it's coming off or where the parallel conection is made? The cab has four 32ohm speakers all wired in parallel. And what about the cap/resistor? Should I put them in, what cap & what resistor?
    Or do I not really need them at all?

    Thanks
    Kevinlee
     
  2. billfitzmaurice

    billfitzmaurice Commercial User

    Sep 15, 2004
    New Hampshire
    Owner, Bill Fitzmaurice Loudspeaker Design
    Parallel is parallel, so just wire it to any of the drivers. As far as using either caps or resistors with them, piezos do not work with them the same way that dynamic drivers do, and correctly wiring them depends on the internal topology of the driver. For the correct way to use them with a particular driver you should contact the manufacturer.