Asking $175 incl. shipping
For those of you who are not aware of these basses, these early 90's European Custom Select Edge basses were crafted in the same Czech factory that Spector used for their first Euro models. It is a 5 piece maple neck with walnut stringers, and a wenge fingerboard. Alder wings and a flame maple cap on the front. The neck profile is slim and the nut is 1.625"
There are a couple dings shown in the pics on the bottom edge from a previous owner, but it is in very good shape overall The color is more of a transparent cherry than the reddish photos can show. Overall this is a very well crafted instrument and an incredible bargain at this price (IMHO
)
As you can see, I am selling it without the pickups or electronics, which I sold earlier this year. The pickup routes are EMG-35 size and, along with any EMG-35's, Duncan SSB-4D's will fit in there, as well as some Nordstrand models including the Big-Splits, Big Singles and Dual coils. I am not totally sure, but Bartolini may make an EMG-35 sized pickup as well. It will accommodate a 4 knob preamp with a panel jack on the side.
I shielded the cavity with the StewMac shielding kit and it's an ok job. I enlarged the Pot holes to accomodate full size pot shafts. I discovered in the course of working on this bass that I would need long shaft pots, so keep that in mind when planning the electronics setup.
For those of you who are not aware of these basses, these early 90's European Custom Select Edge basses were crafted in the same Czech factory that Spector used for their first Euro models. It is a 5 piece maple neck with walnut stringers, and a wenge fingerboard. Alder wings and a flame maple cap on the front. The neck profile is slim and the nut is 1.625"
There are a couple dings shown in the pics on the bottom edge from a previous owner, but it is in very good shape overall The color is more of a transparent cherry than the reddish photos can show. Overall this is a very well crafted instrument and an incredible bargain at this price (IMHO
)As you can see, I am selling it without the pickups or electronics, which I sold earlier this year. The pickup routes are EMG-35 size and, along with any EMG-35's, Duncan SSB-4D's will fit in there, as well as some Nordstrand models including the Big-Splits, Big Singles and Dual coils. I am not totally sure, but Bartolini may make an EMG-35 sized pickup as well. It will accommodate a 4 knob preamp with a panel jack on the side.
I shielded the cavity with the StewMac shielding kit and it's an ok job. I enlarged the Pot holes to accomodate full size pot shafts. I discovered in the course of working on this bass that I would need long shaft pots, so keep that in mind when planning the electronics setup.