Recent content by cwsbass

But it hurts my brain just looking at it.

Magnets.

To go with the p bass body and the four strings it SHOULD have.

Thanks for the info guys. Will get to local electronics store this weekend and pick something up

Hi All I'm currently using a P bass with EMG p/j pickups on it and would like to change one of the volumes to a blend control. Any idea of what value pot to use and where to get one in UK?

Did an outdoor gig a few years back where a friend of mine brought along a pair of Peavey PA cabs to use as side fills. Put them up on stands and fired everything up and there was a snow storm of shredded paper from a mouse nest came out the bottom ports closely followed by a whole family of...

Pretty heavy , very hard.

Hi all I had a clear out of my shed/ workshop a few weeks back and came across a part shaped body that a friend had given me many years ago. I decided it was time to get back to doing something useful with my evenings rather than sit watching crap on the TV so decided to make a guitar for my...

Looking good. Nice job. How does it sound?

Try remelting the solder joints where the input jack is mounted on the circuit board. Used to get a bit of a hum from my TNT150 and that turned out to be the problem. It's a bit of a pain as you have to remove all the knobs from the controls etc to get to the nuts behind ,undo all of them plus...

You could always call the new band "Another Ugly Ape".

Cheers is no bad

Thanks to everyone for your help. Will get this in to a tech this week. Just thought I would have a try myself first. Thanks again.

Hi First timer here. Hope someone can help me. My Ampeg BA210 blow the internal fuse recently.Replaced it ,same thing. Had a look at the boards and noticed two of the ceramic resistors on the power amp board were cracked.Replaced them,same problem. Looked into it on various forums and it...