Recent content by Istrabass

I have the same amp... I cannot find anything on it. Cool Amp though. I had to change out the pots, capacitors and a resistor though. Could you let me know if you find any info on it? Also, How did you even get to the speakers? Is it a front load?

Not a bad idea, I'm new here so I don't DrVenkman. But I will try to get in touch with him. Thank you for the heads up!

So I bought a MM SR5 pickguard ... It's too far off to use. Knobs don't line up, pickuo gap is too small and there's a big gap at the truss rod site. O and the curves by the bridge are off. I don't think it even good for a template... Good idea though... I would if the Sterling is any closer?

Any more pictures?

Thanks guy's. I was hoping someone would step up and just e-mail me a tracing, but whatever. I think I'll use the SR5 template and run with that. Can't be that far off. Thank you @soflbass appreciate the helpful advise. I'll check WDmusic also @spaz, thank you.

I don't have the original pickguard... This is insane to me that this is 2014 and I can't find a pickguard...

I have an OLP MM3 also. I cannot find a pickguard anywhere. A couple of these place said that if i traced the original that they could make a custom one for me at around $100 though... If you find anything, please let me know!

Hello, I was wondering if anyone knew where I could get a pickguard for my OLP MM3 (stingray5 clone). I contacted a few site that told me they could make one if I send in the original or trace it, but I bought it without the pickguard so I'm s.o.l. there. I need the one with the beveled edge...