Recent content by NoahS

Thanks everyone. Obviously I need to learn a lot more before jumping into this. I'll try and find a more suitable power amp in the meantime. Noah

I'm using an Ampeg 810e at 4ohm.

Ok. I'm going to get a 1/4 inch to non shielded 2 conductor wire banana plugs. Using the red poles only to my 810. I'll try both send and direct to see how it goes. I'll grab a small fire extinguisher while I'm out..

It's the first 400rb. Didn't notice any attenuators. So the direct out is the proper one to use?

Maybe the GK and Carvin aren't compatible?

The send volume was lower than the direct.

Ok, tried the speaker out. VERY loud now. That must have been it.

Thank guys. Here's what I've done. Going from the direct out of the GK into channel one of the Carvin. Still not very loud, maybe not any louder than the GK alone.

Hey, I need a little help / advice on setting up a couple new rack components. A GK 400rb and a Carvin FET 450. I love the sound of the GK but I needed some additional power so I got an amp. 450watts or 900watts bridged. I just need to know the proper way to bridge the power amp to get the full...

Not to mention the 2 15's..

Hooked it up the way suggested. Sounds badass. Thank you.

Cool. Thanks.

Just found my Morley ABY.. Would that act as a splitter?

Sweet. I hope I get it right.

I'm totally confused by the impedance safety of this suggestion. Could you explain the math a little more in depth? Thanks.