Recent content by Peval55

I'm not sure I have done it in the right way. By still ... done Thanks.

Could you please share it with me? Many thanks in advance. Ciao

Hi Leo, Could you please send that transcription to me too? Many thanks in advance. Best regards Ciao

HI, do you still having this U-Bass to sell? If yes, could you please contact me by mail? Many thanks.

My mistake in conversion from MM to INCHES. The distances are of course as you said. I have raised up the pickup as close as possible to the strings till when they start to touch the strings while slapping pulling, then move down a bit more just to avoid the buzz. The situation is much...

Thanks to all. I will raise the pickup as close as possible to the strings and let you know if something will change significantly. If not ... ??? But, on the other hand ... 1) The Jim Reed I own has a distances like explained. 2) My teacher has a Sadowky and a GL and the distances are more or...

Thanks a lot for the info. The distance are set according to most of the Bass guitar default setup as: G side bridge pickup 0.787 inches G Side neck pickup 0.59 inches B Side bridge pickup 0.984 inches B Side neck pickup 0.787 inches I think they are closed enough to have a good output...

I did already but I didn't get any answer yet. I will wait a bit longer. But if someone have ideas ... please let me know. thanks

Hi Friends, I very much hope that someone can help me to understand. In my latest Bass guitar, I just built, I have: EMG 40J + EMG 40TW + EMG BTC System. I replaced the volume pot of the BTC system with the Volume with Push/Pull switch supplied with the 40TW. See attached picture that shows...