Recent content by Skatman

Don't buff through your color. Get plenty of clear built up before you wet sand, you want enough on there so that you see dimension, and especially watch your horns this will be the first thing you buff through since nitro has a hard time sticking to points. 10-15 solid coats after color will do...

Your ground needs to follow the the signal path, Im drunk and this isn't the cleanest but check your grounds and make sure you're using the right wires, 2 conductor in the right places

So.. For a defret - step one - slowly heat up each fret with sodder iron 40 watt, pull with fret puller, don't chip fret board. Step two - replace with shim add superglue if going fretless, polish fretboard. For refret - do prior mentioned step one. Step two - bend wire , cut to length, hammer...