Recent content by Stingbass7154

I may have found the problem. There is a line/amp switch on the bass pod. I had it set to amp. When I switch it to line I get sound from everything.

Here are all the inputs outputs

Here are all the inputs outputs.

Here are all the inputs/outputs

Here are all the inputs and outputs.

And now all of the sudden it's not working. I went to the bathroom and came back and now no sound.

I tried each cable from bass to amp without anything else and they all sounded normal. Then I tried the other setup and still no sound. Then I tried a different cable from line 6 to amp and no sound. Then later on it started working with the new cable. Right now I have line 6 input to input of...

That's the only way I can get sound from the amp or from the monitor while using the effects pedal. I rely on the effects pedal because I use effects in every sound I record.

I'm gonna try to test each cable directly from bass to amp to start.

It's a 1/4 cable, just a little thinner. The thing is if I plug directly into the amp from my bass the sound is normal. My last amp I used this same signal chain and everything was fine. Same cables and everything.

Bass to line6/ line 6 (only phones output seems to give me sound) to amp. D.i. of amp to studio.

The only problem is I use effects very heavily because I record experimental electronic music.

That's actually what I have been doing. But I have to use the headphones output from the line 6 into the guitar bass input of the studio.

I have done that. The only way I can get sound with the effects is using the phones jack but it seems like a very hot signal with a lot of treble.

It's actually an input on the effects pedal. I typed that wrong.