Recent content by tuxedobass09

i honestly don't know how it was set up, just give me a sweet way thatll make my bass sound good i just want it working again haha

I think I got everything wired, I didn't mess with one of the wires coming from the pick up, its going in to the push/pull there are 3 wires left, 1 from the neck pick up, and both from the bridge. I just need to know where these are going on the tone knob, or the volume knob, and I'm done...

Traditional p bass pick ups. the bass is 100% stock which is why i can't figure out why there isn't instructionals on how to wire it with this type of pot!

its a split pick up in the middle. I thought they were considered two seperate pickups.

it's a pbass so it has two single coil pickups, all i know is the sound was a huge difference it sounded really trebley when down (on position) and when its up (off position) its really thick and sounds great, i keep it in the off position all the time because i would obviously always want both...

I don't know what category it falls under, I'd say series/parallel but basically before it seemed as if it only had one pick up with in the off position, and when it was in the on position both pick-ups were on because my tone was much fatter. That's how I believe it was set up, this is my first...

It's a stock American P bass, 2005. I have a push/pull switch and I just need to know how it needs to be wired up. I have most wires ready, but the 2 coming from pickups. please a diagram would be awesome. push/pull knob, not s1 switch.