Here is the Amptweaker Bass Tight Drive with Dry Mod.
Shipping Included CONUS.
Designed and built by the gain master himself: James Brown - creator of some classic amps and distortion effects for Peavey.
This is a very versatile and responsive drive/distortion pedal. Capable of everything from light amp-y breakup, all the way up to some intense ripping distortion sounds.
Controls are the following:
- VOLUME: sets the output of the effect
- TONE: a "high eq" control. Acts similar to a guitar tone control, rolling off the high frequencies. Wide open allow for some bright and harsh tones, and dialed back gives smoother and duller sounds if wanted.
- GAIN: sets the drive of the pedal. Allows for serious range from clean-ish boosts through to all out distortion.
- TIGHT: this controls the amount of low-end sent in to the drive circuit. Allowing you to focus the drive and sweep from more aggressive attacking tones, or fattier/woolier distortion sounds.
- the unmarked knob is the DRY level control: this blends in a filtered "dry low-end" which recovers any lows lost by the drive circuit, that blend with the overdrive/distortion rather than just sitting on top or beside the effect. Very useful when the TIGHT control is set higher. Allows for some huge distortion tones!
There is also an effects loop!! This can be set to be pre or post the drive effect and will switch on/off with the main FOOTSWITCH.
This can allow for all sorts of routing and effects possibilities.
Shipping Included CONUS.
Designed and built by the gain master himself: James Brown - creator of some classic amps and distortion effects for Peavey.
This is a very versatile and responsive drive/distortion pedal. Capable of everything from light amp-y breakup, all the way up to some intense ripping distortion sounds.
Controls are the following:
- VOLUME: sets the output of the effect
- TONE: a "high eq" control. Acts similar to a guitar tone control, rolling off the high frequencies. Wide open allow for some bright and harsh tones, and dialed back gives smoother and duller sounds if wanted.
- GAIN: sets the drive of the pedal. Allows for serious range from clean-ish boosts through to all out distortion.
- TIGHT: this controls the amount of low-end sent in to the drive circuit. Allowing you to focus the drive and sweep from more aggressive attacking tones, or fattier/woolier distortion sounds.
- the unmarked knob is the DRY level control: this blends in a filtered "dry low-end" which recovers any lows lost by the drive circuit, that blend with the overdrive/distortion rather than just sitting on top or beside the effect. Very useful when the TIGHT control is set higher. Allows for some huge distortion tones!
There is also an effects loop!! This can be set to be pre or post the drive effect and will switch on/off with the main FOOTSWITCH.
This can allow for all sorts of routing and effects possibilities.
