Recent content by AJQH

I have a couple of pedals that will help, I think, thanks for your comments

Thanks, What I thought about the ef86, just needed confirmation , and you gave it

Some thoughts on using it for Pedal Steel and guitar - It seems to work really well for the PS in the FET channel, not so good with a Tele in either channel, sounds a bit 'sterile' for want of a better description, even using some gain on the tube channel. The tube listed is a 12ax7 do you think...

Fixed!! Thanks very much for your comments, I was running it into a 2 speaker box with one of those fancy multiple ohm inputs, must have been short circuiting through there somehow when I connected the Speakon socket. I had been using it with a 1/4'' plugin for another amp as well without...

My recently purchased Shuttle Max is going into protection mode with very little volume out of the speaker, it is distorted and doing it on both channels so seems like a power amp problem? It was brought to use with a Pedal Steel and Tele to each channel. worked well for the PS, not so much...

Thanks

Do you have any thoughts on using the Max 6 for pedal steel, I like the fact that it has extensive eq capabilities. I am relatively new to PS, but I have seen that others use bass amps, this one appealed because of the parametric eq's available, I have yet to seriously try it

Thanks Aged, have done what you suggested and everything is working as it should

Thanks for your reply, I am planning on using the amp for pedal steel, the speaker I have is a 300w 8ohm, made/voiced for pedal steel and is in a custom made cabinet that uses guitar jacks for speaker connection. The cable I have came made up and doesn't match the +1-1 configuration, I can...

I am wanting to wire a cab to use with my Shuttle amp, the manual say wiring is +1-1 so I take it that they are the only terminals used out of the amp so, I need to connect the wires in the cable so that is is +1-1 between the amp and speakers. I have a Neutrik cable with 2 wires but they don't...