Recent content by alexinasuitcase

Thank you @fig, just what I was after! Seems there is a much simpler way of doing this than I was able to muster up haha

Thanks a lot for the help on that @rojo412! I think that based on what you have said I may be using the term "blower switch" incorrectly though, so my apologies there. What I was trying to emulate with it was the same thing that I have in my LP Classic – the tone for the bridge pickup is on a...

Hello anybody, I'm currently in the middle of modding a Squier Bronco Bass but due to my lack of knowledge with the electronic side of things I'm having some trouble working out if my wiring diagram is going to work, or more so, work as I want it to – I was hoping to get someone to help confirm...

The current plan I have is to install some kind of Rickenbacker-esque pickup at the bridge. I saw an old thread of a Bronco build where someone replaced the middle pickup with a Nordstrand 51P4 (with 17mm spacing) so I'm currently leaning towards doing that too. I figure that would be a nice...

I think the dual gang pot sounds like the perfect solution to my problem – thanks for the suggestion! That will allow me to keep it to 3 control knobs and have the 3-way switch as well. From what I know about the Broncos (I don't actually have the bass yet) the body is pretty thin, so I doubt...

Yeah my plan was to add in another control knob where the jack input was and then have a side-mounted jack, and the DPDT switch next to the jack. Ideally I would like a maximum of 3 control knobs though as I don't require separate tones for each of the pickups, one master tone works fine for...

Thanks guys – this is super helpful, and also good to know it’s possible! In terms of the rest of the wiring, are there any existing diagrams I could use as a basis for this? The separate volumes master tone is basically a JB setup, but I’m not sure how I’d then go about incorporating the...

Hey, my first post here! So I’m wanting to modify a Squier Bronco Bass and wanted some help with working out the electronics and wiring. I’ve not personally seen this done before, so I’m not 100% sure whether what I want to do is actually possible (so if not please let me know), and I am aware...