Recent content by guzzler

  1. G

    Widen String Spacing At Bridge for Fender Standard MIM Mexico Jazz Bass V 5 String

    Thank you
  2. G

    Widen String Spacing At Bridge for Fender Standard MIM Mexico Jazz Bass V 5 String

  3. G

    Widen String Spacing At Bridge for Fender Standard MIM Mexico Jazz Bass V 5 String

    This is a 5 String Bass I am talking about.
  4. G

    Widen String Spacing At Bridge for Fender Standard MIM Mexico Jazz Bass V 5 String

    Thanks Sissy Kathy. Have you tried to widen the spacing on a 5 string that you have ? I am not sure how much this could be widened before the outer strings would seem to be getting close to the edge of the fingerboard. Also wondered at what spacing the strings would be centered over the pole...
  5. G

    Widen String Spacing At Bridge for Fender Standard MIM Mexico Jazz Bass V 5 String

    Has anyone tried to widen the 17mm spacing on their bass ? I wondered if anyone makes a replacement bridge for the Fender MIM 5 String Jazz Basses ? A bridge with wider than 17mm spacing or one with adjustable spacing. I would like to widen the string spacing. I have the original bridge and I...
  6. G

    Series Parallel Switch mod on EMGs

    I had read some people saying they liked the sound of the EMG-HZ humbuckers better when they were wired in parallel vs series. I wondered how the EMG HZ would be wired when in a bass from the factory. Like a Schecter Bass with the EMG HZ. It seems like I have seen a lot of the Schecters with...
  7. G

    IBANEZ ARTCORE TONE PROBLEM SOLVED !!!

    By changing the pots to 50K, do you guys notice a difference in the sound and output or is it just in the effect of the tone control on the sound. Since you are going from 500K to 50K, what if you wired the pickup directly to the jack ? I realize you would have no volume or tone control but how...
  8. G

    SOLD Phat's MM-4 pickup & pre sale

    Just sent 'conversation' about a pickup. Is that same as what used to be a PM ?
  9. G

    SOLD FS: Kala U-Bass Fretless Solid Mahogany, Dead Mint 1/2 Price

    Sent PM
  10. G

    Neck for Schecter Diamond Series AB-1 AB1 AB 1 (Avenger ?) Bass ?

    here is a photo of the heel. fretted or fretless necks would be okay.
  11. G

    Neck for Schecter Diamond Series AB-1 AB1 AB 1 (Avenger ?) Bass ?

    Here are a couple photos It has/had a 24 fret neck with overhang at end of fingerboard.
  12. G

    Ibanez SRX Bass PFR Pickups Preamp & Balance/Blend Control

    Did you feel like the sound changed when used without the preamp ? but you had the pickups in different basses so that would be a factor also I guess.
  13. G

    Ibanez SRX Bass PFR Pickups Preamp & Balance/Blend Control

    Ibanez SRX Bass PFR Pickups Preamp & Balance/Blend Control Hello, I am thinking about the SRX bass electronics. I have been trying the bass with the EQ set to the flat points. Trying each pickup soloed and also with the balance control centered. I seem to not find where it sounds 'right'. I...
  14. G

    Ibanez SRX Bass SRX4EX1 Truss Rod & Nut Removal

    Hello, do you guys know if the truss rod nut is removeable on an Ibanez SX4EX1. Looks to be 2006 model, made in Indonesia. I went to adjust the neck and the truss nut nut has been rounded out. I had an SRX505 that was Korean made (Cort factory I believe) and had a similar problem and found...
  15. G

    Lookin for a pair of EMG-MMCS

    it says your message folder is full
See more
Top Bottom
Back