Recent content by JJ Kaos

I know this an old thread but I've recently had to change a driver in one of my 8x10 cabs. When I took the damaged one out, I noticed that it was labelled as 26.5 ohms and not the usual 32 ohms. I've had the cabs since new so I knew that it was an original speaker. Over the last week, this has...

Hey, Sorry for the delay on this. Ok, from completely flat, I put it on charge and within two hours, all three LEDs were lit. Not sure if that meant it was fully charged or not so I still left it on for the recommended six hours. I then took it to the studio and after about thirty minutes use...

They say that it takes 6 hours for a full charge but I've only charged mine once so far because I only got it on Friday. I couldn't tell how long it took because it already had the 3 LEDs lit when I first unwrapped it and turned it on but I still put it on charge for the recommended 6 hours...

I just got a Volto, specifically for running a G50 and although it's early days, so far it does what it says on the tin. Obviously the G50 receiver draws a lot of current compared to regular effect pedals, so I was a bit concerned whether the Volto would be up to the job. I didn't get anywhere...