Recent content by John Sankalis

I know this is an old thread, but when Conrad Sundholm re-created the cabinet plans for me for the 200S cabinet, he mentioned an Eminence equivalent. When I inquired about which one, he replied sonically the CB15 would be his choice. Just had to make sure the magnet didn't interfere with the...

Well......my Century is dead. Power light comes on....but no output. Was hoping to run the preamp into an outside power amp via the booster output. Still no output. Was told "it just stopped working". Looks like something liquid got knocked over. Thanks for all everyone's help in getting it...

Sorry for the delay answering your question. Mine has. Volume and Presence. Thanks for your post. Thanks for the manual as well. Never saw this one. Think I saw the "B" one.....4 power transistors.

Thanks for the replies and suggestions. Much appreciated. From pictures I've seen, there were even differences between the 120 and 200. Besides the additional 2 power transistors. Have a Great Day all!

Acquired an "early" 60 watt version of this amp. I have the schematics but am still confused as to where the jack is supposed to be wired in. At this point...there isn't one. I see where a wire goes from the jack to the "pin" on the PC board on the power amp. I've seen a couple of pictures of...

Saw you were going to build a copy of the T100. Did you ever build it? Can you tell me what the actual angle on the baffle/grill frame is! Thanks! John

I must have an "early" Peavey Century 120 Series. It only has two output transistors as opposed to four on the later ones. Back panel says 60 Watts into 8 ohms instead of the usual four ohm rating. Can this version of the Century even run a four ohm load.....Thanks!