Recent content by Lark

Hey guys, long time no post. All my pedals have been a success thus far. I finished the envelope filter, the compressor and the muff with mid boost. The "mid" pot on the muff works as required, however, when turned completely counter clockwise, it cuts out the sound out altogether. I imagine...

I'm literally in the middle of doing the same thing. Hopefully trying to add a pot to scoop and boost the mids. Do a google search for "big muff mods" and you should get a bit of info. Keep me posted how you go. I've recently started to build effects myself.

Has anyone heard or seen anything about the 2 new bbe compressors? I've only seen the stuff on their website.

Hey guys. Does anyone have any suggestions on the grounding wires? I've used a star ground from the input jack sleeve to the dc jack, the circuit, the footswitch and the output jack sleeve. I am making a bass fuzz, and I am getting bypass signal and LED works, but no effect signal. I suspect...

Hey guys, I'm working on the big muff at the moment. I'm adding a mids boost pot to the effect which shouldn't be too difficult. I am just wondering where each if the pot lugs are soldered to. I imagine one or two lugs would go back to the pcb, but which one? And where would the other be...

Not too concerned about the fuzz/distortions, however I would be keen to hear how the compressor sounds...

Can you do any audio recordings?

Sorted the looper blender out and now works fine with the LED. Now working on an envelope filter, and trying to finish off the bazz fuss and Ross comp clone.

Tested the Splitter and it works fine. Just need to figure out the issue with the LED. Hopefully wont be too much. Then i will move on to finishing the Bazz Fuss and Envelope filter.

It's not horrendously messy, just I only have one colour wire and is hard to see what is where. Reflows all the solder points on the pot lugs. Not PCB mounted, I've made this on vero. I'll try and get a photo, but I feel like it is something to do with the pot. I'll try what you said ibanez.

Update on the bazz fuss. Took it all apart and resoldered the grounds. Put it back in and had bypass, no signs of shortage (power supply light not flashing), no effect signal when engaged. I put a bit of pressure on the pot lugs and had faint sound, but nothing when I would take my finger off. I...

Hey guys, just wanted to give an update/seek more advice haha. At this stage my builds are as follows: single knob bazz fuss with led and 3pdt, a GGG Ross compressor, a buff n blend splitter looper and GGG ef440 envelope filter. Have a few questions for each: Bass fuzz- all soldered, sound...

The guitarist has a joyo tremolo. I tried it out and thought it was pretty good. The LED is pretty funky. If I could find an application for one myself, I would think it would suffice. Can't compare to the mooer, as I haven't tried it. I think the majority of Joyo stuff is pretty good, and can...

Yeah pretty sure it's a grounding issue, as out of the enclosure works (reasonably) fine and in the enclosure bypass works, but nothing when engaged. Its my first "proper" effects build, donuts a bit messy and with longer than necessary wires. I'm thinking that I may need to order and drill a...

I just modded a bad monkey and it sounds surprisingly good, so good that I want to keep it. I'm about to make a blueberry od, tuned big muff with mids control and a loop blender. Ill let you know how it goes!