Recent content by psychepool

I thought, In many ways, rather than getting a long screw it would be better to add wood to the screw hole of the pickup route to raise the height of the route itself This is because it is compatible with other common pick-up mount screws. Thanks anyway!

Is the screw diameter M3? If it is 40mm long, it seems to be enough. However, it is worrisome that the screw thread will start with the screw head and break the pick-up cover screw hole. Anyway, thank you! I think it's best to buy offline, but unfortunately, there's no local hardware store...

I'd like to mount Dimarzio DP122 in my bass custom route. But the route was worked too deep. So the length of the screw is littel short. So the height of the pickup cannot be adjusted as high as desired. I'd like to find a product that's a little longer in the same spec as the dimarzio mount...

Thank you for your good opinion. I will also wire with 250K and .047.uF. It's because I like little dark sound rather than bright sound.

Thank you for your answer. I wanted to hear the empirical opinions of people who have wired this pickup for various parts values. I'm also thinking about implementing both versions with push pull pots. If there is no change when the switch is operated, I think it would be better to wire to the...

I bought a Dimarzio Model P. When I looked for the wiring diagram to install it, I found that there was not much information. Firstly, I planed to wire it like a typical P pickup : 250K Volume and Tone pot, .047uF cap. But this is what the official website of DiMarzio says :500K Volume and 250K...

Thanks for the good advice. Unfortunately, work has already been done. The next time I get a chance to do this again, I'll consider it. Of course I do not want that happening...

"Or just properly fill any cavities you cut on the front and refinish the entire top." I'm doing it like this way. There is no proper tool, so the job is very rough. I hope to finish it well.

JC is a full-hollowed body and does not have a center block. There are additional wooden frames in the center of the top and bottom plates, but it's not "blocks." I also know that it is not a wise plan. And I also know that this bass has a very good identity. The low-impedance pickup also has a...

While I wait for an answer, I set the direction to some extent and I am working on it. Thanks for your answer anyway. I wonder if there is a pickup ring that can mount the P pickup separately from whether it is applied to my work.

Did I misrepresent the situation? The P pickup is direct mount, so a bottom plate is required for mounting. That product does not have a bottom plate, so it can not mount the pickup and looks only for the purpose of covering the visible side for looks good. My question is about the pickup...

Is there a pickup ring that can mount the P pickup? I also search the pickup rings but there's no ring for mountthe pickup, only just for aesthetic purpose.

I do not certain what to write the title. Anyway, there is one question. I wrote this before. Double P bass pickup wiring question. Because of that idea, I am forced to surgery on this unique and beautiful bass. I upload the plan image to explain it briefly. I want to try this. Jack Casady...

You give me a big inspire to add the 2 pickup series mod. I don't think about it before you mention about it. Thank you so much!

Are you talking about PB-555? I like the Pbass type sound, but I have never used it on the bridge. I am pleased to hear the sample, so I want to hear the results. Other sound sample of double p bass. I like every mode of this bass. The bass that i apply to is hollow bodied bass but I expect...