Recent content by rxbandit79

I used that 16ohm diagram because that was really all I could find on the internet that looked like it was wired how i did it. it's the same using 4ohm speakers, the only thing that would be different is the final impedance. (4ohms rather than 16ohms as the diagram I posted) are you trying...

this is basically how I ended up wiring it, only with 4 ohm speakers obviously... look about right?

So, I blew a speaker in my Ampeg410HLF cab a couple years ago, and I'm finally getting around to replacing the speaker. I drew up a diagram as I pulled out the bottom 2 speakers so I would be able to re-wire everything without any problems... however, now that I'm looking at the diagram I...

Awesome, thanks will33.

Anyone know where I can find a replacement speaker for a Carvin RL410T? I got the cab about 5 years ago, and after I blew one of the speakers, I've been using it as a coffee table... Need to sell it, but I have a feeling I can get a lot more for it if it works :)

Thanks alot anderbass! you always seem to be a great help to me. So you are saying (because I have the "High Frequency Horn Level Control" on my cab) I will need to disconect this and make sure all the other speaker connections are completed without this correct? Thanks for all your...

Let me give you a background of what I'm playing with, then i'll get into the problem. I am running an early 70's Ampeg V4/VT22 through a Ampeg SVT610-HLF. I have the amp plugged into a Monster Power Conditioner so the ground is good and the power is clean. Recently, I have been getting a...

alright... I'm back... same problem, only worse this time i think... so I got the amp on last night, awesome... then when I was done playing on it, the power switch wouldn't go down to turn the amp off... finally after working at it, I got it to catch and switch down, however, now the amp...

Thanks guys, that actually seemed to be the problem. I took out the fuse holder and fiddled with the prong in there, then I moved the fuse connection on the head and it seems to have fixed the problem. Thanks again for your help

alright... I'm having some major trouble with my vintage Ampeg V4... The past few times I have gone to play, my head wouldn't turn on at first. I would pull out the fuse, check it out, everything looks fine, put the fuse back, and it turns on fine. Turns on fine, plays fine for as long as I...

Awesome, thanks anderbass for all your help and input

awesome, thanks guys

Alright... I don't know if this is possible, but I'm tired of letting the sound guy at venues set my tone that comes through the monitors to the crowd. I'm running a '73 Ampeg V4. My question is, is there a way to go direct out of the head, into a direct box to go to the mixing board...

I just purchased a vintage Ampeg VT-22 bass head and was wondering if anyone can give me any insight as to how good (or bad) these heads are. Also, I will be running it through an Ampeg 6-10. Will these be compatible? Thanks!

So, I was looking on Ebay this weekend and found a 67-68 Fender Coronado I Bass... only trouble is, I can't find much about it online... any time I search, it suggest my search should be for a Coronado II Bass... Does anyone have any info on this? maybe an average cost it should be, or any...