wiring for j-bass

  1. chappy2807

    Really weird Jazz Bass wiring

    Today I picked up a 90s Fender AVRI '62 Jazz Bass, which I'd noticed had had the control switched to the post '62 VVT setup, over the original VTVT Stack knob setup. Upon getting home, I'd noticed the jack was completely corroded beyond use and went to replace it with a spare PureTone I have...
  2. bassistrdn

    Washburn XB-500 wiring diagram missed

    Hello everyone; dear friends: I recently acquired a Washburn Bantam XB-500 5-string bass with no wires connected to the potentiometers inside the body. I'm asking for your kind help. The bass is already restored and partially finished. But I can't continue with the remaining part (The...
  3. 2

    Treble bleed, wiring mod and volume taper for passive Jazz Bass

    Hello! I'm about to mod the wiring harness of a Jazz Bass by the help and professional work of a luthier and guitar tech. The guitar's body is MIM '97, however the pickups were switched by the previous owner to MIJ passive single coil pickups, but I don't know more about them. I assume they...
  4. F

    Help with spicy Jazz Bass wiring?

    Hi, I have this jazz bass which i changed the wiring time ago adding a push pull switch for series/parallel options, (I followed the classic Seymour Duncan wiring that appear as the first result in google images). Days ago i was wondering if i could find a way to balance the sound between the...
  5. JJ08

    What should i buy for repainting a P-bass and adding a jazz pickup

    I already have what i need for the pickup cavity and the pickups, but I'm mainly concerned with stuff for painting and electronics. What should i buy for repainting a bass, and what should i get for soldering and stuff? Specific products would be really helpful; ideally not too expensive, but...
  6. L

    Looking for 3 wire Jazz Pickup

    The jazz pickup on my PJ is unfortunately not up to par. I like the pickup, but the "A" string sounds weak compared to the others. To the point where I think the pole is dead. This isn't an issue with the P pickup, and I actually didn't notice it until recently, since I mostly use the p pickup...
  7. BassChuck

    Wiring advice needed

    Back story: I have a J-Bass with Nordy humbuckers into an Audere J3. The preamp has died and I'm replacing it with a standard passive J-Bass control plate. Question: The pups each have 4 wires; red, green, white, and black. The white and black leads are joined, but not wired into the Audere. The...