As many others said, the Bertolini BH2 are very muddy, and that's why I wanted to wire them in parallel, but I'm confused with their wiring.
So, as you can see on this picture, the black and bare are on cold(Yellow colored), and the white is on hot(Orange colored).
And as you can see here, the red and green are connected together.
In another thread someone said that:
Neck side coil: Green - ground, White - Hot
Bridge side coil: Black - ground, Red - Hot
Bare wire is ground
But I'm confused how I can change this on parallel and why this is series rn.
I’m also confused why bare is with black on cold and white on hot.
In another thread someone said that:
Neck side coil: Green - ground, White - Hot
Bridge side coil: Black - ground, Red - Hot
Bare wire is ground
But I'm confused how I can change this on parallel and why this is series rn.
I’m also confused why bare is with black on cold and white on hot.
