building advice

[antiunderscores]

How do you drill the holes for the wires coming from the pickups to get them to the controls on natural finishes? similarly the pickups that are actually off the pick guard.

If it was painted my idea was to rout the path out either on the front or the back then glue a thin veneer on top. I'm really more asking this out of curiosity than anything else, because I don't plan on making a stained bass any time soon but if i were to make one for someone else it's good to know ahead. cheers

 

[Jensby design]

Put the out jack on the side
sorry if I lost you,just thick about that one
(it will take a long drill bit)
you could also hide one with the strap button

 

[SDB Guitars]

When I do it, I use what is called an aircraft drill bit. It's ~18" long, and small (I use 3/16" bit).

After routing for the pickups and the control cavity, I drill from the neck pocket all the way down to the bridge, and then I drill from the bridge pickup route into the control cavity. That way there is a hole running from the neck pickup cavity into the bridge pickup cavity, and then the bridge pickup cavity is connected both to the control cavity, and to the location of the bridge, for the purpose of grounding the bridge

Make sense? It's almost 1:00am here, so I'm not *entirely* sure how much sense I'm making, but it makes sense to *me*...

 

[Jensby design]

Make sense? It's almost 1:00am here, so I'm not *entirely* sure how much sense I'm making, but it makes sense to *me*...

its 3:00am where I'm at,your doing fine

 

[antiunderscores]

although mine is a bolt on neck what if i were to eventually make a neck-through design?

 

[Jensby design]

you could also hide one with the strap button

you just use the smallest bit you can find then fill the hole with a dowel so you have something to screw the strap button into
does anyone understand me
wait just drill the hole before you glue the wings on.
I had to go change a diaper,but I have pics I want to show you when I get a chance

 

[antiunderscores]

you just use the smallest bit you can find then fill the hole with a dowel so you have something to screw the strap button into
does anyone understand me
wait just drill the hole before you glue the wings on.
I had to go change a diapers,but I have pics I want to show you when I get a chance

thanks for that , that will really help.

 

[Jensby design]

Note no front or back plate yeah,thats how I roll



but how did he do it?
where is the 4th string on that thing?
will Clayton ever figure out how to use a computer?
tune in next week for the shocking conclusion ! !

 

[T2W]

although mine is a bolt on neck what if i were to eventually make a neck-through design?

You gotta plan ahead for that. since the pickups are always wider than the actual neck blank, you can simply route a channel on the side of your neck blank and then when you route for the pickups, the channel is magically revealed. yep. then with a long drill bit, you drill ahole from the bridge pickup to the CC. Its pretty easy, just always gotta plan ahead. Imagine putting in Leds.