1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

I would appreciate some help

Discussion in 'Hardware, Setup & Repair [BG]' started by vassjunkie, Feb 24, 2010.

  1. vassjunkie


    Feb 19, 2010
  2. elgecko


    Apr 30, 2007
    Anasleim, CA
    One for each of two pickups?
  3. vassjunkie


    Feb 19, 2010
    ahhh, I see thank you, I'm new to the whole bass thing.

    This can be closed
  4. +1

    OP, you will note a difference in sound between each of the pickups. You can get a degree of tone control from favouring one pickup over the other.
  5. ianbannister


    Jan 9, 2013
    Does anyone know how to remove the knobs on an Ignition bass? I want to replace them with the white type that I think look better. There's no grubscrew and I've pulled as hard as I dare so far without success. Any advice?
  6. 96tbird

    96tbird PLEASE STAND BY Supporting Member


    Take a towel and slide the edge under the skirt of the knob. Wrap the edge of towel around and under the entire knob. Gather towel all in one hand so it is holding the knob evenly from under and wont slip out. Pull up. It will pop right off