LM3 line out to PA?

[winndaddy]

Lost owners manual and I'm still a noob when it comes to anything PA, amps, ect... Anyone with a LM3 ran it directly to a PA? Is it possible? And if so, which line out do I use? Will my effects still work being ran threw the front?

 

[Russell L]

Run a mic cord (typical three-prong XLR plug) from the D.I. on the back of the amp. Then, you can control the amount of signal sent with the knob on the front labelled Line Level. It's a very good and quiet D.I. so they tell me.

 

[winndaddy]

Thanks, I figured I wasn't going to get a response since my question was so complete and utterly noob like. One more question if I may please. Should I get a speaker cord with a microphone like adapter for both ends?I have a speaker cord but it has the 1/4 plug on both ends.

 

[BurningSkies]

Get a cord that's XLR female on one end and XLR male on the other end.

 

[pacojas]

do NOT use a speaker cable into a P.A. board, please!!!

 

[Jim Carr]

do NOT use a speaker cable into a P.A. board, please!!!

+1

It will hum...but I think he just meant cable.

 

[dave_bass5]

im pretty sure you can download the manual from the MB website, this will show you whats what.
Only the XLR will give you the EQ and filter section (and i believe the FX loop) on the output.

 

[winndaddy]

Gotcha! Thanks guys!