1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Mark III Centurion???

Discussion in 'Amps and Cabs [BG]' started by Broncrider32, Dec 12, 2003.

  1. Broncrider32


    Feb 21, 2003
    I have a Peavey 130 watt @ 4 ohms Mark III Centurion. I am running one 8 ohm 15" cab I was wondering if it was possible to plug into both outputs in the back and send it to the one input in the back of my cab in order to get my full 4 ohms...
  2. BillyB_from_LZ

    BillyB_from_LZ Supporting Member

    Sep 7, 2000
    The speaker jacks in your amp are connected in parallel with one another. Plugging two cables into one speaker cabinet won't change the load that it presents to the amp.

    To load the amp to 4 ohms in order to draw full power, you'd need to add another 8 ohm cabinet or replace your existing cabinet with one rated 4 ohms. You'd probably get better results adding another 8 ohm cabinet.

Share This Page