image.jpeg

For sale Markbass F1 price Drop Again!!!300

Sold
$300.00
Status
This item has been sold and is no longer available!

Details

Classic quick Markbass tone! Well enjoyed, used casing doesn't hold this unit back!

$300 shipped

TECHNICAL SPECS
INPUTS

INPUT
impedance 500 Kohm, max. voltage 15 Vpp
EFFECT RETURN
impedance 22 Kohm, max. voltage 25 Vpp

CONTROLS

GAIN
-80 dB to +25 dB range
MASTER VOLUME
GROUND LIFT
switch on rear panel

EQUALIZATION

LOW
center frequency: 40 Hz; level: ±16 dB
LOW MID
center frequency: 360 Hz, level: ±16 dB
HIGH MID
center frequency: 800 Hz, level: ±16 dB
HIGH
center frequency: 10 kHz: ±16 dB
VPF (Variable Pre-shape Filter)
center frequency 380 Hz (cut)
VLE (Vintage Loudspeaker Emulator)
frequency range 250 Hz-20 kHz (cut)


OUTPUT

LINE OUT
balanced XLR, max. voltage 10 Vpp
EFFECT SEND
unbalanced, max. voltage 20 Vpp (pre-EQ)
TUNER OUT
unbalanced, max. voltage 25 Vpp
SPEAKER OUT
speakon / 1/4" (x2)


OTHER

WEIGHT
4.63 lbs / 2.1 kg
DEPTH
10.04 in. / 25.5 cm
WIDTH
10.87 in. / 27.6 cm
HEIGHT
1.73 in. / 4.4 cm (1U)
OUTPUT POWER
300W RMS @ 8 ohm, 500W RMS @ 4 ohm
POWER REQUIREMENT
100V; 120V; 230V; 240V
50/60Hz
(Voltage is factory preset according to region of sale
  • image.jpeg
    image.jpeg
    618.5 KB · Views: 449
  • image.jpeg
    image.jpeg
    572.1 KB · Views: 408
  • image.jpeg
    image.jpeg
    576.7 KB · Views: 423
  • image.jpeg
    image.jpeg
    626.5 KB · Views: 388
  • image.jpeg
    image.jpeg
    542.5 KB · Views: 396
  • image.jpeg
    image.jpeg
    415.3 KB · Views: 405
  • image.jpeg
    image.jpeg
    579.2 KB · Views: 417
  • image.jpeg
    image.jpeg
    401.1 KB · Views: 405
  • image.jpeg
    image.jpeg
    314.7 KB · Views: 401
  • image.jpeg
    image.jpeg
    343 KB · Views: 404
  • Like
Reactions: G RICH 5

Comments

May 15, 2012
1,961
506
Alabama
Im asking the previous owner. Good question. I would have mentioned that but I don't know what it is.
 
May 15, 2012
1,961
506
Alabama
image.jpeg
Not an issue I just took one of them off. It's was not hard, didnt scratch the case and the other is the same material. It was probably for rack case to give cushion berm tweet units for some reason but it's all good.
 
May 15, 2012
1,961
506
Alabama
I thought it was to prevent something from scraping if the t was rack mounted but that may be the case. I have not noticed any metal vibration sounds.

Still available!
 

Classified ad information

Posted by
lax4bags
Feedback score
+96 /0 /-0
Category
For Sale: Amps, Preamps, and Cabinets
Views
3,528