So if you caught my earlier thread on this rig ,I brought it home.
Also the cabinet is a SVT 410 pro rated at 600 watts
I hooked it up with my 2-10 HE cab to get down to 4ohms and viola, I am a believer in Ampeg again.
I was in the attached garage and was ratlin the wall on the other end of my house.
Whether its the tube preamp or the extra 100 watts or a combination of the 2,, there is a world of difference from my 350 watt B2r at a 4 ohm load.
If it dont melt down like the guys did in the other thread, I probably have the head I"ll use for a long long time.
I have a question though. This older model amp has one banana plug output or 2 1/4 outputs, and the cabinets say both jacks are full range inputs.
Would you piggyback 2 banana plugs from the amp to each speaker enclosure, use 2 1/4 inch cables to each enclosure,or run out of the 4-10 into the 2-10 cab?
(does full range inputs mean it can be used as an in and out on Ampeg?)
I appreciate all the input on the old thread and any future help on this wiring question.
LOWfreq
Also the cabinet is a SVT 410 pro rated at 600 watts
I hooked it up with my 2-10 HE cab to get down to 4ohms and viola, I am a believer in Ampeg again.
I was in the attached garage and was ratlin the wall on the other end of my house.
Whether its the tube preamp or the extra 100 watts or a combination of the 2,, there is a world of difference from my 350 watt B2r at a 4 ohm load.
If it dont melt down like the guys did in the other thread, I probably have the head I"ll use for a long long time.
I have a question though. This older model amp has one banana plug output or 2 1/4 outputs, and the cabinets say both jacks are full range inputs.
Would you piggyback 2 banana plugs from the amp to each speaker enclosure, use 2 1/4 inch cables to each enclosure,or run out of the 4-10 into the 2-10 cab?
(does full range inputs mean it can be used as an in and out on Ampeg?)
I appreciate all the input on the old thread and any future help on this wiring question.
LOWfreq
