Please help on Modulus Flea neck again !

[MRPaulFunk]

i just wanted to make the neck have no relief (Straight neck)
i tighten the trussrod many many time, it doesn't move.
and when i tighten it, is kindda not resist my hand, i have to turn it 5 times in a roll to make it a littlebit resist my hand, then when i go up for another round it loosen again, so is like this.

**notice** i turn 5 times in one round because the rod is not resisting, i guess is ok to turn it five time in a roll.

first quarter > Loosen
second quarter > Loosen
third quarter > littlebit resist
forth quarter > littlebit resist
fifth quarter > Loosen

then wait and play it for about 10 min.

and check if is move....notting, but i also heard about a Modulus neck system that only and loosen it. or maybe is
that?

thanks for reading all of this, bless to all TB nice user.

 

[MRPaulFunk]

Anyone?

 

[EricssonB]

Problem should be somewhere within the collective of these:
-- piece of crap/quality problems
-- stripped-out threads
-- could use a professional setup.
That's my start.

 

[MNAirHead]

I'd start by clamping

 

[basskillah]

While looking directly at the truss rod, remember righty righty and Lefty loosley. If you're telling me that's what you did, then your truss-rod is probably broken. There's no way you could make 5 revolutions on the truss rod, and have no movement in he neck. Unless its broken.

 

[basskillah]

Are your bridge saddles set ridiculously high?

 

[MRPaulFunk]

Problem should be somewhere within the collective of these:
-- piece of crap/quality problems
-- stripped-out threads
-- could use a professional setup.
That's my start.

have no idea where should i start, lol

I'd start by clamping

kinda serious stuff, and for sure it don't have in the place i'm living: (

While looking directly at the truss rod, remember righty righty and Lefty loosley. If you're telling me that's what you did, then your truss-rod is probably broken. There's no way you could make 5 revolutions on the truss rod, and have no movement in he neck. Unless its broken.

or graphite neck is hard to adjust? , or maybe it need an extra turn ?.

Are your bridge saddles set ridiculously high?

is pretty low, actually is buzzing little bit if i played deep in the neck.

 

[dannylectro]

If you are getting five full turns on the truss rod, it is probably broken, or the threads are stripped. Time to take it to a professional.
Good luck.

 

[Dave W]

If you are getting five full turns on the truss rod, it is probably broken, or the threads are stripped. Time to take it to a professional.
Good luck.

This. Especially since you mention it has no resistance when turning it.

FYI: You should really only be turning it 1/4 turn at a time. Otherwise you risk breaking it.