QSC rmx 1450 with Ampeg 810

[Gertok]

I am confused what cable do I need to run it bridged on 4 ohms.
If I understand it right. Ampeg says 4 ohms mono is 1+ 2+ (1/4" inputs or speakon) Otherwise it 8 ohm if top 1/4" input used.... Qsc has 2 speakon outputs and 4 outputs with + and - for both channels ( I am not sure how they are called... the kind you screw and unscrew, marked black and red for + -). 2 reds from these are for bridged mode... but what cable do I need on the ampeg end... Ahhhmmm I am confused... help

 

[zultimatez]

if your running speakon, you only change the end your plugging into the amp to 1+/2+, you run the other end normal.

 

[Gertok]

Can you give me a picture from any online store how this cable should look like

 

[Gertok]

alright I found manual for ampeg... the lower 1/4 or speakon in ampeg from mono bridged output from the amp. So i will need fork looking connector to connect 2 red outputs from the amp, and a 1/4" or speakon to connect to ampeg or a speakon to speakon.... easier than i though