1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Schaller 3D-4 bridge Shims.

Discussion in 'Hardware, Setup & Repair [BG]' started by NielsBass, May 12, 2011.


  1. NielsBass

    NielsBass

    Apr 30, 2010
    I have a Fender Jazz bass with a Schaller 3D-4 bridge installed.
    The previous owner has installed that bridge and while i have nothing to complain about the quality, I found strings too high for my liking so I removed the Shim underneath it.
    At first the bridge was waay too low, but i adjusted the screws to raise the strings to their max and it played pretty well.
    But lately I get annoyed a bit by the fretbuzz and would like to raise the string a bit more, but when I install the shim the strings would be too high again....

    Does anyone know if there are thinner shims around I could install instead of the 1 I got with bass?

    Seems like Schaller only sells 1 size shims:

    Shim 3D-4 () | Schaller-Electronic
     
  2. fretlessfivefun

    fretlessfivefun

    Sep 19, 2010
    Stock they come with 3mm, you can also buy 4mm from them.

    I say take a block sander and sand it down yourself and then repaint it.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.