Using ( 2 ) Ampeg B25 together

[Jeffbe20]

Hello, I am new to this page so please bare with me.

I just picked up ( 2) Ampeg B25's. I am looking for guidance as to whether I can run both at the same time. I can do this with both of my SVT's using both my 8X10 cabs and all works fine just by using my line-out on one, and the input on the other.

I am new to the B25 and don't want to fry them by experimenting. Not worried about the 16 ohm cab that is needed for these yet. Just want to know if these to can be run together, and how ?

I see there is a guy named Chris out there who knows these B25's inside and out....

Are you still out there..?

 

[throbbinnut]

Plug your bass into Amp A. Run a cable from the line out on Amp A and into the line out on Amp B, or you can run from Amp A line out to input on Amp B. It'll work either way, but you'll be able to control the volume on Amp B independently using the volume control on Amp B if you run into the Input.

Chris

 

[Jeffbe20]

WOW, you do exist...I think I am going to like this forum..: )

Would there be any kind of setup using these 2 amps together that would allow me to use one of my 8X10 SVT Cabs that are 4 ohms ?

Jeff

 

[RickenBoogie]

Both heads must have a proper load, (speakers) connected. Otherwise- Failure.

 

[Jeffbe20]

Thanks....

I just received 1st one and it is actually a B25-B. Thought the discription just said B28.

Thanks for the quick info...