Warwick Rockbass, active pickups no preamp!!!

[johnsid]

I've been wondering what if I remove the onboard preamp from my Rockbass Corvette Classic but not the active pickups.
But as I don't want to damage any electronic parts inside the cavity I thought I'd better use new pots.
Seymour Duncan recomends for their active pickups 100k pots but Warwick has a complely different layout for their Invalid Link Removed so my question is what should I use, are 100k pots ok for my bass or I'll have to use higher or lower values?

 

[tedsalt]

Active and Passive Bass Pickups

Umm ... the warwick diagram shows a passive setup. Are you using the original Rockbass pickups? If so, you don't need the preamp, and you can use a control assembly as illustrated in the warwick diagram.

If you have active pickups, you'll need a preamp and whatever pots the pickup mfr recommends (or something close).

 

[rojo412]

If there are red wires going directly from the battery to the pickups, you have active pickups.
If the pickups just have a hot and a ground, you can consider them passive.

I'd use 25k pots for the volume if active pickups.
I'd go with 500k pots if they are passive pickups.

 

[johnsid]

As I have mentioned above they are active pickups.Sadly there is no active pickup only schematic, everything on the Warwick site has the preamp on and since the pickups are quite expensive I 'd like to give them a shot before I move on to something else.
My problem is about pot values, thanks Rojo412 by the way, but I also need values for blend,neck tone,bridge tone, so additional info would be appreciated!

 

[rojo412]

Look on EMG's website. I forgot if blend pots use strange values or not, but they'd have a diagram.

 

[johnsid]

Active and Passive Bass Pickups

Umm ... the warwick diagram shows a passive setup. Are you using the original Rockbass pickups? If so, you don't need the preamp, and you can use a control assembly as illustrated in the warwick diagram.

If you have active pickups, you'll need a preamp and whatever pots the pickup mfr recommends (or something close).

You mean that I might be able to try the existing values without the preamp?Right?