Wilkinson WSME4 active bass humbucker

[cokesodanotdrug]

I recently purchased this humbucker off ebay in hopes to use it on a cheap bass i got at a pawn shop, the only problem is I can't figure out how to wire this bad boy. It has 4 wires coming from it, Black, White, Red, and Yellow. The white and red are already soldered together if that helps.

I've looked everywhere online, sent emails to various websites that have wilkinson pups listed on their sites and have so far returned with no info. I'm getting pretty desperate.

looking for a simple 1 volume 1 tone diagram.

Any help is greatly appreciated!!!

Thanks!

 

[aquateen]

maybe this will help you out

http://www.guitarelectronics.com/category/.wiringresources.11pickupcolorcodes/

you really only have to figure out which is the ground and which is hot for the remaining wires. to determine which is ground, use a voltmeter to do a continuity test. a competent guitar tech should be able to help you out if necessary.

as for the wiring, a P bass diagram would fit the bill. good luck!

 

[cokesodanotdrug]

so I don't have to worry about wiring up a battery into the circuit? if that's the case then this is easier than I'm making it out to be.