Winter Build Off 2019- Li'l Ricky 330BS

[GeraldMcG]

The rainy week wasn't a complete waste of time. I did start getting this bad boy set up in my garage. A Harbor Freight mini mill.

Not sure if I will be far enough along the learning curve to make parts for this or my other current builds but I will be using it to make some bass parts I have been designing.

 

[GeraldMcG]

Also had the time for to go to a screen printing workshop with my bands singer. A good skill to have for headstock logos, amp control panels and of course band merch.

Murder Fish isn't my current band. Just a silly design I came up with but everyone who has seen the t-shirts asks if it is a band so I think it will be the name of my punk/ska side project.

 

[GeraldMcG]

Template time. Rough cut some MDF. I'll fine tune it on the orbital sander over the weekend.

Since I have one I figured I might as well trace the outline from the genuine article.

 

[GeraldMcG]

While I was cutting the template the sawdust inspector showed up.