Acoustic Image (AI) Clarus 2R Series III - $550 Shipped
Acoustic Image is the defacto standard for upright bass and for the amplification of all acoustic stringed instruments.
This is a clean Acoustic Image Clarus 2R Series III in good condition. A very few minor dings and scratches from use, but everything works as it should.
I'll upload pics in the next day or so.
Below are the specs:
SYSTEM
Frequency Response: 20 Hz - 20 kHz, +/- 0.5 dB
Distortion: < 0.5% full output, < 0.1% typical
Hum and Noise: -85 dB or better
AC Power: 115V/50Hz, 230V/50Hz, switchable (Japan version 100V, 50/60Hz only)
Size: 10.2" W x 8.2" D x 3.5" H
Weight: less than 5 pounds
PREAMP: inputs through combo front panel jack
Mic input: 600 ohm balanced, XLR connector
Phantom power: 38 volts, on/off switch w/LED indicator
Instrument input: 1 Megohm impedance, 1/4" jack
Direct out: + 4dB, balanced, XLR connector, ground lift, pre/post EQ selector
Effects loop: Parallel type with return level control
Bass control: Shelving type, + 15dB @ 60 Hz
Mid control: + 15 dB @ 650 Hz
Treble control: Shelving type, + 25dB @ 10 kHz
Notch filter: > -18dB sweepable from 30 to 800 Hz
Low cut filter: -12 dB / octave, sweepable from 30 to 800 Hz
EFFECTS
Type: Digital with 6 presets and level control
Program presets: 3 reverb(hall, room, plate), delay, ambient chorus, flange
POWER AMP
Topology: Class D, (PWM)
Switching Frequency: 200 kHz
Output Power: > 250 Watts (8 ohm), > 400 (4 ohm), >500 W (2 ohms)
Minimum Load: 2 ohms
Output Connectors: Neutrik Speakon type (pole 1)
INCLUDED ACCESSORIES: Gig Bag with shoulder strap, 6 foot Speakon to 1/4" cable
AVAILABLE ACCESSORIES: twist-lock to twist-lock speaker cables
twist-lock to 1/4 inch speaker cables
Acoustic Image is the defacto standard for upright bass and for the amplification of all acoustic stringed instruments.
This is a clean Acoustic Image Clarus 2R Series III in good condition. A very few minor dings and scratches from use, but everything works as it should.
I'll upload pics in the next day or so.
Below are the specs:
SYSTEM
Frequency Response: 20 Hz - 20 kHz, +/- 0.5 dB
Distortion: < 0.5% full output, < 0.1% typical
Hum and Noise: -85 dB or better
AC Power: 115V/50Hz, 230V/50Hz, switchable (Japan version 100V, 50/60Hz only)
Size: 10.2" W x 8.2" D x 3.5" H
Weight: less than 5 pounds
PREAMP: inputs through combo front panel jack
Mic input: 600 ohm balanced, XLR connector
Phantom power: 38 volts, on/off switch w/LED indicator
Instrument input: 1 Megohm impedance, 1/4" jack
Direct out: + 4dB, balanced, XLR connector, ground lift, pre/post EQ selector
Effects loop: Parallel type with return level control
Bass control: Shelving type, + 15dB @ 60 Hz
Mid control: + 15 dB @ 650 Hz
Treble control: Shelving type, + 25dB @ 10 kHz
Notch filter: > -18dB sweepable from 30 to 800 Hz
Low cut filter: -12 dB / octave, sweepable from 30 to 800 Hz
EFFECTS
Type: Digital with 6 presets and level control
Program presets: 3 reverb(hall, room, plate), delay, ambient chorus, flange
POWER AMP
Topology: Class D, (PWM)
Switching Frequency: 200 kHz
Output Power: > 250 Watts (8 ohm), > 400 (4 ohm), >500 W (2 ohms)
Minimum Load: 2 ohms
Output Connectors: Neutrik Speakon type (pole 1)
INCLUDED ACCESSORIES: Gig Bag with shoulder strap, 6 foot Speakon to 1/4" cable
AVAILABLE ACCESSORIES: twist-lock to twist-lock speaker cables
twist-lock to 1/4 inch speaker cables