For sale Spector HAZ preamp

Cstan · Jan 9, 2016

Total noob question here, this guy should just drop straight into a euro4lx without any routing right?
Thanks!

Dominick C. · Jan 9, 2016

Cstan said:
Total noob question here, this guy should just drop straight into a euro4lx without any routing right?
Thanks!

I had to enlarge the holes for the pots and slightly carve the PCB to get one in my old Euro. I had installed the mighty mite version. Not sure if this one is differently sized, but the photo looks similar. The upgrade was worth it

99Z3 · Jan 9, 2016

You will have to open the holes up just slightly for the knob shafts.. and remove a very very small amount in the control cavity maybe. The Euro cavity is a tad smaller than in the USA Woodstock basses in general.. I had it in a CRFM and it took me all of about 15 minutes to get it in there..

Cstan said:
Total noob question here, this guy should just drop straight into a euro4lx without any routing right?
Thanks!

99Z3 · Jan 9, 2016

And if you have noticed, I have left the wires that go to the jack in place. I didn't remove them.. so you will just have to connect the pups and the bridge ground (if you are using passive pups).

99Z3 · Jan 9, 2016

On Hold Pending Funds

S.O.T.G. Rich · Jan 14, 2016

If you don't sell it I'll buy

99Z3 · Jan 14, 2016

It is sold

Search

For sale Spector HAZ preamp

Details

Comments

Cstan

Dominick C.

Guest

99Z3

Guest

99Z3

Guest

99Z3

Guest

S.O.T.G. Rich

99Z3

Guest

Classified ad information

Share this classified ad