Fender Jaguar Wiring Schematic?

[BruceBass3901]

Hello there guys

I'm currently part way into building a Fender Jaguar copy and can't seem to find any wiring diagrams or schematics. Can anybody lend a hepling hand here? It would be very much appreciated

Thank you

 

[johnk_10]

 

[FuNkyLoWNotEs]

sweet thanks...printed a copy and keeping in my case!!

 

[FuNkyLoWNotEs]

also, my series/parallel switch is now wired backwards and it has more electronics "noise" than ever haha. I am prolly gonna have to take it somewhere else.

 

[GreggBummer]

I had my Jag modified so I could use each pick up independently. Here is the thread:

http://www.talkbass.com/forum/f8/my-modified-fender-jaguar-check-out-789712/

 

[RonnyRobinson]

My Fender Jag bass has begun creating a lot of noise when im not touching the strings, so i thought id have a nose under the input plate. While doing this, a wire has come off and i cant tell where from! Ive seen the wiring diagram posted above but it looks different to what i have here! Urgent help required!

 

[Blue9]

Can anyone tell me the pot values for #11 and #12?

My master tone only modifies the tone by a small amount. I'm going to check the cap, but since pots are cheap I was thinking of replacing the pot/cap entirely.

The active tone rollers (#12) don't do anything at all. I've triple-checked the wiring and everything is correct. Again, figured I'd replace the pots and see what happens.

Lastly, if I were to wire in an onboard fuzz effect would this work:

Replace Volume with stacked Tone/Volume.
Replace Tone with Push/Pull.
Output from light green (#24) into fuzz, then out of fuzz into newly installed Push/Pull, then out of P/P into jack?

Another idea was that if I can't get the active tone rollers to work, to wire the fuzz to one of those rollers. But I don't even have a guess as to how the wiring would work. I'm assuming if I disconnected the wires from those pots that go to the pre-amp that it would kill the active side of the bass. Can I bypass the rollers by just connecting the purple/grey wires and the dark green/orange wires?

 

[BassoSaku]

Previous owner has replaced the original PU:s with Bartolinis which have a nice sound in passive, but the active side is botched. Any experiences if this is something that regularily happens because of x when ppl change pickups to Jaguar Deluxe Bass?

 

[Libertine80]

Hi! How about wiring Fender Jaguar CIJ bass 2006 without preamp and upper horn controls? I want to keep everything original, except of preamp and upper horn controls. So, there is V+T controls and three switches (neck on/off, bridge on/off and paraller/series).

I found the wiring diagram from here, but in my case, where input jack hot is going for example? Anything else I need to know? Thanks!